Fly Mark Mark on fly: choosing this item refers to enable the “Fly mark” function. Fly from right to left: Choosing this item indicates that stream line direction is from right to left. Fly continue mode: Choosing it indicates mark object is a continuous one, namely, we need to mark content on the continuous object.… Continue reading F3 Configuration Parameters: Other – Fly Mark and Red light pointer
Ezcad Manual
Ezcad Ezcad2 Ezcad3 laser marking software using manual, such as function introduction, parameter setting, etc..
We also provide Ezcad download here (software, manuals, drivers, etc.).
F3 Configuration Parameters: Other
Starting Mark Delay: The delay before marking. Finish Mark Delay: The delay after marking. Max Power Delay: The Max dealy when the laser power is changed from 0% to 100% during marking. When the power’s range is changed less then 100% during marking, the time is less proportional to the Max vaule. This function is… Continue reading F3 Configuration Parameters: Other
System Parameter: General
In “General“, common parameters can be configured. Unit Type: millimeter and inch are two options can be selected. Paste X and Paste Y: the relative offsets to the previously object when paste. Grid: show or hide the grid. Grid distance: adjust the distance in grid. Input IO mask: user could choose IO port through input… Continue reading System Parameter: General
F3 Configuration Parameters: Port
Stop mark input port: When in marking process, if the system detects there is a corresponding input signal, the current marking operation will be ended, and prompt the users with error information. Door IO: Check the port signal for opening and closing of the safety door. When the safety door is opened, processing will automatically… Continue reading F3 Configuration Parameters: Port
Transformation: Mirror
mirror the currently selected object. A parameter setting box will appear when selecting the mirror command, as the Figure shows. Scale: the zoom ratio of the X/Y size after being mirrored. The current object’s vertical mirror. The current object’s horizontal mirror. Select a datum mark of an object. Apply to copy object: This item is… Continue reading Transformation: Mirror
Edit Menu: Hatch
“Hatch” is used to force EzCad to calculate the hatch fills for the current objects. The object to be filled must be closed curve, and if you choose many objects to fill, these figures can be objects nested mutually. Any two objects may not have intersectant parts. Related faqs: The Hatch is not complete?The dxf… Continue reading Edit Menu: Hatch
AngleRotate Marking: Invert, Step per rotation
Invert: Reverse the move direction of the expansion axis. Pulses per rotation: The pulse numbers each round that the expansion axis rotating. We can calculate it through following formula: X=(360/N)* n Thereinto: X denotes Pulses per round.N denotes step angle of step motor.n denotes micro-step set by step motor driver. Min speed: the minimum rotary… Continue reading AngleRotate Marking: Invert, Step per rotation
AngleRotate Marking: Zero, Finish goto start position
Goto start position after finished: The expansion axis will go back to the initial position after finishing marker. Speed: The speed of the axis going back to the initial position after finishing marker. Zero: Whether current expansion axis has zero-switch input signal. Without zero signal, the software can’t build up an absolute coordinates. Marking a… Continue reading AngleRotate Marking: Zero, Finish goto start position
Four Delay Time: Laser On TC, Laser Off TC, End TC, Polygon TC
Laser On TC: When the scanhead has to execute a mark command, the scanner mirrors first have to be accelerated up to the defined marking speed. In the beginning of the movement, the laser focus moves very slowly which may result to burn-in effect at the start point. To avoid this, We insert a delay… Continue reading Four Delay Time: Laser On TC, Laser Off TC, End TC, Polygon TC
