Fault: Ezcad automatically changes the default parameters

in FAQs about Laser Marking,

Specific situation: After the continue mark mode is unchecked and the marking is completed once, the software automatically returns to check the mode.

Fault cause: The computer anti-virus software accidentally deleted the Ezcad source file.

Solution: Use the Ezcad installation package to cover and replace the previous folder.

Suggestion: It is not recommended to install anti-virus software on the computer for laser marking. If necessary, please add the Ezcad software folder to the whitelist.

Leave a comment

Your email address will not be published. Required fields are marked *