Fly Mark
Mark on fly: choosing this item refers to enable the “Fly mark” function.
Fly from right to left: Choosing this item indicates that stream line direction is from right to left.
Fly continue mode: Choosing it indicates mark object is a continuous one, namely, we need to mark content on the continuous object. (Such as wire, cable, and so on).
Enable total part num: Selecting it indicates the mark “total number” set is effective.
Enable simulation: It indicates that using simulation hardware method produces linear speed. It requires appointing speed.
Enable mark entity by order: Selecting it indicates that software will mark content according to its order in the list in turns. Otherwise, software will mark content according to its position in working space from left to right.
Reverse encoder Signals: the signals from encoder are reversed.
Reverse encoder offset: the position of marking is in front of actual.
Inport: choose port of flying signal for Board Version 2.2.6 or update.
Fly speed: The calculation formula is shown as follows:
Fly speed coefficient = perimeter of coder tachometer wheel / coder pulse per revolution;
Red Light Pointer
Enable show contour: When selected, the red light show the object frame, not the rectangle made from the max coordinate and the min coordinate of the object.
Enable continue mark mode: enable this function, return the software surface, click “Param” and then the dialog box popup shown as the following Figure, it will appear after the mark stop every time, the Red Laser Pointing always exists.
Light Speed: the speed of guide light.
Offset Pos X and Y: it is used to compensate the position error between guide light and the laser beam.
