The laser marking machine sometimes slows down, which is caused by the default parameters in Ezcad2.
How to adjust the marking speed of laser marker?
First, enter the laser marking machine software Ezcad, and deselect the Use default param on the right.
Change the value, such as the default Speed is 500, you can adjust it to 1500 or more.
However, after adjusting the speed, the marking effect will not be clear enough.
At this time, you only need to change the default Power of the marking machine from 50 to 60~80.
It is not recommended to adjust the power to full.
What should I do if these parameters are restored to default after entering the software next time?
After the value is reset, click Apply to default below to set the default value.
