How to wire for the laser rotary mark board?

in FAQs about Laser Marking, , ,

(1) Galvanometer mode: no short circuit is connected. At this time, rotary marking does not work.

(2) Rotary mark mode: short-circuit IN0 and GND for the mark board, and support bitmap, vector graphics, text and other processing modes.

(3) Scan mode: short-circuit IN0, IN1 and GND for the mark board, this mode is only suitable for filling processing in the vertical direction of the Y axis, and cannot be used for vector graphics and edge-to-edge printing.

Leave a comment

Your email address will not be published. Required fields are marked *