Laser Marking Machine Opening Steps

in Blog

1. Check the power cord of laser marking machine to make it connected correctly and reliably.

2. Insert the key switch, turn it 90°clockwise to the “on” position, turn on the main power.

3. Confirm that the mushroom button (emergency stop switch) is in the pressed state.

4. Turn on the power switch of the computer monitor and the computer host.

5. Rotate the red mushroom button in the direction of the arrow to make it pop up, and the laser can be powered on. UV laser starts to complete after about 1 minute.

6. Remove the lens cover. At this point, the laser marking machine is turned on, and the marking operation can be performed by accepting the operator’s command.

Leave a comment

Your email address will not be published.