Marking: Mark-Control Bar

in Ezcad Manual,

The Mark-Control Bar is located at the bottom of the main interface window, as Figure shows.

Mark-Control Bar

Light: This item is used to mark the frame of the object without laser output so that users are convenient to orient the workpiece. This function is available in those laser machines which have guide light.

Key “F1” is the shortcut key of this function for guide light show.

Mark: to execute marking.

Key “F2” is the shortcut key of this function.

Continuous: mark the objects repeatly until user stop the mark.

Mark Selected: only those selected objects would be marked.

Part: the total counts that the mark command has been executed.

Total: The total counts that the mark command should be executed. The value would decrease 1 automatically after the mark command has been executed each time. It is unavailable under the mode of Continuous Marking. When in marking process, if the amount number is more than 1, the marking operation will not stop until the marking number is 0.

Parameter: machine parameter.

Key “F3” is the shortcut key of this function.

Leave a comment

Your email address will not be published.