Sometimes when using the laser marking machine, there are some problems due to misoperation or resetting the marking software Ezcad2, such as: the red light pointer of the laser marking machine does not display the outline.
How to solve?
Method 1
Check it directly at the bottom of the Ezcad2 software interface.
Method 2
Enter the specific settings interface for more detailed settings.
Click Param(F3) – Other – Red light pointer, here is the setting of the red light.
Check Enable Show contour, Enable continue mark mode, and click OK.
It should be noted that this function is only valid in the laser marking software ezcad 2.14 version, if the Ezcad2.76 version is used, it will not take effect. So if you need this function, use ezcad2.14 version.
In addition, there is another situation, that is, the red light device is damaged and needs to be replaced.
