Red light size is not right? It is unstable and spinning? not clear?

in FAQs about Laser Marking, ,

The red light is not the right size partly because galvanometer correction has not been done, so galvanometer correction can be done first;

The red light is unstable and spinning, you can click “F3 parameters”-“Other”-“Red light pointer“, by increasing the red light speed, the situation of red light can be changed;

If the red light is not clear, you need to change the offset and size ratio, and adjust the overlap of the red light and the laser light.

f3 other
red light point 2

Leave a comment

Your email address will not be published. Required fields are marked *