Except the new option 360 degree mark, the others parameters in AngleRotate2 is the same as those in AngleRotate. 360 degree mark: Selected to mark the figure on the column evenly. Total num: The count of figure that will be marked on the column with evenly interval. If we don’t check 360 degree mark, Increment… Continue reading Laser Menu: AngleRotate2 Marking
AngleRotate Marking
AngleRotate Marking: Invert, Step per rotation
Invert: Reverse the move direction of the expansion axis. Pulses per rotation: The pulse numbers each round that the expansion axis rotating. We can calculate it through following formula: X=(360/N)* n Thereinto: X denotes Pulses per round.N denotes step angle of step motor.n denotes micro-step set by step motor driver. Min speed: the minimum rotary… Continue reading AngleRotate Marking: Invert, Step per rotation
AngleRotate Marking: Zero, Finish goto start position
Goto start position after finished: The expansion axis will go back to the initial position after finishing marker. Speed: The speed of the axis going back to the initial position after finishing marker. Zero: Whether current expansion axis has zero-switch input signal. Without zero signal, the software can’t build up an absolute coordinates. Marking a… Continue reading AngleRotate Marking: Zero, Finish goto start position
