The laser marking machine itself is famous for its fine, clear and beautiful marking effect, so many users buy it for this. However, if the operation is improper or other factors affect, the marking effect is likely to be blurred or deformed. What should I do if the marking lines printed by the laser marking machine… Continue reading What should I do if the marking lines printed by the laser marking machine are bent?
Driver
How to Select or Change the Driver of Laser Marking Card in MarkingMate?
Based on the different marking controller usage, user must select a correct driver. Users need to select the driver when installing MarkingMate. Besides, they can also change the driver by executing Driver Manager through the following path: Start – Programs – MarkingMate System – Utility – Drv Manager
The gap is dislocated in the split marking of ezcad2?
1. Check the parameter settings of the drive, and adjust the number of pulses per revolution and the step distance according to the parameters. 2. Confirm whether the moving direction of the platform is parallel to the cross line of the galvanometer. 3. Check whether the calibration is accurate. 4. Check the backlash error of… Continue reading The gap is dislocated in the split marking of ezcad2?
After the driver is installed, the ezcad software still prompts that the dongle cannot be found?
Win10 64-bit, the driver installation has been displayed, but the software prompts that the dongle cannot be found, what should I do? First, the marking board does not require an external dongle. Then check the followings: 1. There is a mismatch between the driver, board, and software. Try changing the software version. 2. Check whether… Continue reading After the driver is installed, the ezcad software still prompts that the dongle cannot be found?
It often shows that the LMC cannot be found effectively or the LMC hardware version error?
1. Is the power supply 5V3A? 2. The EZCAD software version and the LMC board do not match. 3. When the error is reported, is the driver in the device manager normal? Related: Error: Can not find valid lmc1 device
What should I pay attention to after reinstalling the system?
You need to reinstall the laser mark control board software driver, dongle driver(for Ezcad3 ), and make or directly import correct files.
How to Install the Driver for Ezcad2(Laser Mark Control Board V2)?
How to install the driver for laser mark control board v2 to use EzCad2 software normally? For using a laser marking machine with Ezcad2 software, install the driver for the laser mark control board v2 step by step. Step 1 Turn on the machine’s power. Connect the laser marking machine and computer by data cable.… Continue reading How to Install the Driver for Ezcad2(Laser Mark Control Board V2)?