There are two reasons why the laser marking machine does not respond after changing a foot switch: 1. The signal line is not connected to the interface. Check whether the 1-pin and 14-pin or other pin ports of the con4 interface of the laser marking board are connected. 2. Software settings. It may be that… Continue reading Why does the laser marking machine not respond after changing the foot switch?
Input Port
Draw Menu: Input Port
To check the Input signal, users can select command “Input Port” in the Draw Menu or click the icon. When selected, there will be an input port property setting appearing in the Property Toolbar as Figure shows. I/O Control Condition: The software will pause until the input signal is the same as the I/O control… Continue reading Draw Menu: Input Port