Input Port Number 1 2 3 0 Status Description Pin Number 21 11 12 16 Signal Status 1 1 1 1 IPG laser: reserved 1 1 1 0 Fiber laser: not ready 1 1 0 1 IPG laser: reserved 1 1 0 0 Fiber laser: not ready 1 0 1 1 Fiber laser: system failure… Continue reading IPG Fiber Laser Status Signal Table
IPG
EzCad Error: “IPG Laser: Reserved”
The possibility of failure: 1. The data cable between the laser and the marking contorl board is in poor contact (re-plug or replace the data cable). 2. The optocoupler of the laser marking control board is burned out. 3. The laser is broken (mainly the signal part). There is a high probability that it is… Continue reading EzCad Error: “IPG Laser: Reserved”
Ezcad error: IPG laser temperature is too high
The laser marking machine did not run for a long time, and the marking software Ezcad reminded that the IPG laser temperature is too high. What is the reason? How to troubleshoot? 1. The temperature of laser marking machine is too high Due to the operating environment and weather, the heat dissipation effect of the… Continue reading Ezcad error: IPG laser temperature is too high
Special Menu: IPG Setting
Click IPG Setting in Special menu, the following dialog will pop up. It connects the computer and laser through serial line for series of IPGM laser, and the laser can send the status signal of themselves to the software, like temperature, and power state. After pressing the button to connect, all lights before the laser’s… Continue reading Special Menu: IPG Setting
Error message: IPG Laser: Power error!
Laser alarm – check laser status (troubleshoot the laser.) or power off and restart. If the fault disappears after restarting, it is generally caused by a problem with the laser power supply. Consider replacing the 24V laser power supply. If it is a laser fault, a similar alarm will still appear, then the laser needs to be… Continue reading Error message: IPG Laser: Power error!