Stepping on the foot switch continuously, there will be a stuck phenomenon, and the marking will fail twice. The computer configuration is not low, what is the reason? If it is a 2nd generation laser mark control board, in Ezcad2, Param(F3) – Other, check the Enable marking start signal lock.
LMC Board
Is it normal that the indicator light of laser mark control board is not seen after powered on?
There will be a green light when the laser mark control board is powered on. If the indicator light does not light up, it may be that it is broken.
Why does adjusting the power of CO2 laser marker in Ezcad have no effect?
CO2 laser marking machine, adjusting the power in Ezcad seems to have no effect, is it because the laser mark control board is broken? First check whether the signal connected to the laser mark control board is correct. Whether the CO2 laser is using PWMTTL signal. Check if there is any problem with the signal line. Then… Continue reading Why does adjusting the power of CO2 laser marker in Ezcad have no effect?
What should I do if the marking lines printed by the laser marking machine are bent?
The laser marking machine itself is famous for its fine, clear and beautiful marking effect, so many users buy it for this. However, if the operation is improper or other factors affect, the marking effect is likely to be blurred or deformed. What should I do if the marking lines printed by the laser marking machine… Continue reading What should I do if the marking lines printed by the laser marking machine are bent?
How to wire for the laser rotary mark board?
(1) Galvanometer mode: no short circuit is connected. At this time, rotary marking does not work. (2) Rotary mark mode: short-circuit IN0 and GND for the mark board, and support bitmap, vector graphics, text and other processing modes. (3) Scan mode: short-circuit IN0, IN1 and GND for the mark board, this mode is only suitable… Continue reading How to wire for the laser rotary mark board?
EzCad Error: “IPG Laser: Reserved”
The possibility of failure: 1. The data cable between the laser and the marking contorl board is in poor contact (re-plug or replace the data cable). 2. The optocoupler of the laser marking control board is burned out. 3. The laser is broken (mainly the signal part). There is a high probability that it is… Continue reading EzCad Error: “IPG Laser: Reserved”
The USB cable of LMC board cannot be connected to the computer (no communication)
The USB cable does not communicate with the computer, that is, the laser marking machine is not connected to our industrial computer, so the laser marking machine software Ezcad will not play any role. How to troubleshoot? 1. Check whether the USB cable is loose. Re-plug the USB cable on the computer side, and then re-plug… Continue reading The USB cable of LMC board cannot be connected to the computer (no communication)
The secondary development ezcad prompts lmc1_Initial error21
Under the premise that the standard software emits light normally: 1. The library used is not a custom library. 2. The board card does not have the corresponding secondary development support function enabled.
It often shows that the LMC cannot be found effectively or the LMC hardware version error?
1. Is the power supply 5V3A? 2. The EZCAD software version and the LMC board do not match. 3. When the error is reported, is the driver in the device manager normal? Related: Error: Can not find valid lmc1 device