1. The computer configuration is low; 2. The laser mark control board is disconnected; 3. Caused by the computer’s anti-virus software; 4. Ezcad installation problems. These reasons may cause the Ezcad software to crash.
Marking Board
Why can’t the modified file be saved in Ezcad2?
It is found that the two options of Save and Save As under the File menu are grayed out and cannot be clicked. The modified file cannot be saved. What’s the problem? There are two possible reasons. 1.The Ezcad2 software is a trial version. 2.This problem occurs when the laser marking machine is not turned on and connected… Continue reading Why can’t the modified file be saved in Ezcad2?
Is it normal that the indicator light of laser mark control board is not seen after powered on?
There will be a green light when the laser mark control board is powered on. If the indicator light does not light up, it may be that it is broken.
How to use one PC to control multiple laser marking machine software ezcad for marking?
If multiple marking boards are required to control multiple lasers and gavlo, connected to the same computer, the marking boards need to enable the multi-head function and dial different serial numbers on the DIP switch. Each marking board is connected to the PC, and the multi-head marking software is opened to set the marking area… Continue reading How to use one PC to control multiple laser marking machine software ezcad for marking?
I turned off the marking software Ezcad, but the laser is still marking.
Fundamentally speaking, this is a normal phenomenon, because the marking command and marking content of the Ezcad software have been sent to the marking board. If you close the software, it is equivalent to waiting for the board to execute the last command, and it will be out of control. It may grow light the… Continue reading I turned off the marking software Ezcad, but the laser is still marking.
How to use a computer to control multiple lasers for marking?
Multiple marking boards are required to control multiple lasers and galvos (up to 8), and to connect to the same computer. The boards need to enable the multi-head function and dial different serial numbers on the DIP switch. Connect each board to the computer, open the multi-head software to set the marking area of each scanner(galvo) ,… Continue reading How to use a computer to control multiple lasers for marking?
Laser marking board card is lost during the marking process?
a. Check whether the equipment is effectively grounded. b. Check the interference source on the equipment site and do shielding treatment. c. Check the wiring method of the equipment, and the weak current and strong current of the equipment are required to be wired separately, and isolation protection should be done. d. Check whether there… Continue reading Laser marking board card is lost during the marking process?
What should I do if the edited drawing in ezcad cannot be saved as a file?
The marking board ①should be plugged into the computer, ② must be powered on.