Possible problems: 1.The correction file is wrong. 2.The focal length is wrong. 3.The surface of the material is uneven or not leveled. 4.The workbench is not flat. More read: EzCad2 Correction File: 9-Point Calibration Manual
Marking Size
How to adjust the box of ezcad workspace to the actual marking area size?
File – System parameter – WorkSpace, adjust the size value.
The red light of the laser marking machine is inconsistent with the actual marking range, how to adjust?
During the marking process, it is found that the actual marking and the red light range are inconsistent, how to adjust? 1. Open the laser marking machine software Ezcad, and draw a rectangle in the working area, for example, a rectangle with a size of 60mm*40mm. Then mark on the demo workpiece. 2. Do not… Continue reading The red light of the laser marking machine is inconsistent with the actual marking range, how to adjust?
How to adjust the marking path error?
The path error of the laser marking machine actually refers to the deviation of the marking size. How to adjust this? 1. First mark a 30x30mm square in the working area of the laser marking machine. 2. Use a vernier caliper to measure the square, and record the lengths of two sides, one for the… Continue reading How to adjust the marking path error?
How to Expand the Marking Range of Laser Marking Machine?
If we need to mark large-format products, but find that the laser marking machine can’t mark so large, how to do? In fact, this time to replace a field lens can solve it. Field lens, also known as flat field focusing lens, scanning lens, F-theta lens, is a necessary accessory for laser marking machine equipment. The… Continue reading How to Expand the Marking Range of Laser Marking Machine?
How to set the marking range of laser marking machine?
1. Open the System Parameter of the laser marking software EzCad, find the WorkSpace, and then change the data. For example, if our field lens size is 175, we will change the Width and Height of Size to 175, and then change the X Y of Left bottom corner to -76.5. 2. Open the Param… Continue reading How to set the marking range of laser marking machine?
The marking size does not match the actual one, it is too large or too small?
The marking size is not correct. If the accuracy requirement is not particularly high, it is recommended to do nine-point correction or internal correction.