If you encounter this problem: When you select the continuous marking mode, the MOPA laser engraver emits light for a short time and then stops emitting light immediately, only the red light, no laser.
You can do the following steps to use continuous marking mode in EZCAD3 successfully:
1. First, you should turn off the foot pedal port:
F3->Port->Start Marking IO: Port -> null
2. F3->Laser Control:
1)Type and Pulse Width
Laser Type：IPG_YLP(Type:D)
Enable pulse width setting: True
Set MO after pulse width change: True
duration delay: 10us
Others: False
2)Laser emission
MO Always open: False
