What Are the Basic Marking Steps of Laser Marking Machine?

in Blog,

Turn on the machine – Import files – Set parameters – Start marking – Turn off the machine.

The specific marking steps of laser marker are as follows.

I. Turn on the machine

1. Check the power cord of the laser marking machine to make it connected correctly and reliably.

2. Insert the key switch and rotate 90 degrees clockwise to the “on” position to turn on the main power. The power indicator light will be on.

3. Confirm the laser head mushroom button (emergency stop switch) is pressed.

4. Open the computer monitor and host power switch.

5. Rotate the red mushroom button along the direction of the arrow, so that it pops up, you can turn on the laser head power. After about 1 minute, the laser head start completed.

6. Remove the lens cover. So far, the laser marking machine is open and can accept the operator’s command for marking.

II. Marking

1. Double click the laser marking software icon (such as Ezcad2) to enter the program.

2. Select the marking file, check and modify the date and time in the content.

III. Marking test and printing position

1. On the workbench or production line, place a test piece of equal height to the original workpiece (preferably choose the original workpiece as the test one), and make sure it is indeed placed steadily.

2. Marking is performed by operating the software. In order to make the best marking effect, the following operations can be performed.

①Adjust the focal length by adjusting the laser head lifting device.

②Adjust the power, marking speed and other parameters in the marking software.

③Adjust the printing position to the appropriate place.

3. After completing the above steps, you can print the test.

4. After the test is correct, re-mark on the workpiece.

IV. Start marking.

V. Turn off the machine

After the processing is completed, the operation steps to shut down the laser marking machine are as follows.

1. Press the red mushroom button (emergency stop switch) to cut off the laser head power.

2. To confirm that the computer is not running any marking software, then exit normally and shut down the machine.

3. Rotate the key switch 90 degrees counterclockwise to the “off” position, turn off the laser marking machine total power supply, power indicator off.

4. Unplug the key and have someone to keep it for the next use.

5. Cover the lens cover.

The above is the basic process of laser machine marking operation, strict implementation of the operating procedures to avoid injuries.


How to Install the Driver for Ezcad2?
What Checks Are Required for Laser Marking Machines Before Operation?

Leave a comment

Your email address will not be published. Required fields are marked *